FANUC 31i-B5 5-Axis VMC and FANUC 31i-B 4-Axis HMC are what I'm looking at at the moment. I've got a few FANUC Manuals and none have 5109 listed that I can find. That Parameter Section however relates to Canned Cycles. So unless you're doing some sort of Canned Cycle, that parameter may not be the answer. I'll poke around and see what I can dig up.
We are setting up tool life management (TLM) on one of our Matsuura HPlus-630 Fanuc 31i. We don't need redundant tooling so we are not planning on using the group TLM. We're going to use the TLM on the tool manager page. We would like to put a notify value and have the machine throw a user messag...
I have read up a little on the "G05.1" command for the older style Fanuc control. The newer 16i was a lot easier to comprehend. I was hoping somebody out there could give me a run down in english (control manual reference). From what I can gather, and correct me if I am wrong, the output shoud be...
I have a new machine with a Fanuc 0iMc control I bought it with 120 blocks of look ahead in order to contour and surface at higher feed rates. Could someone please give me an explaination of how to get this to work? I have been reading the manual and it tells me to use a G8. An examle of some cod...
JP whatever happened with this customer? was it the fanuc parameter? thanks Tim!! i will change those parameters in our 18i and 31i controls since this has happened